Cookie politik

Websitet anvender cookies til at huske dine indstillinger, statistik og at målrette annoncer.
Læs mere her...

 
0
0,00 GBP Show basket
Menu

Installation instructions with transfer foil.

Important! When you get your wall sticker!

When you receive your wall sticker, first unpack it from the tube and check that it matches your order. You must then lay it out flat, leave it for approx. 1 day before installation.

It is very important that you clean the surface that your wall sticker will be on. Wash the surface with soapy water, wash well with clean water and let the wall dry for at least 2 days. Testa always go your vägg först with the bifogade Provet, oavsett vilken väggtyp väggklistermärket ska vara on. Then you are ready to put up your wall sticker.

NOTE! Do not put your wall sticker on a freshly painted wall, wait here 1-2 weeks, so you are sure that it is COMPLETELY dry.

Installation - step by step:

  1. Take a scraper, ruler or Dankort and rub over the back of the wall sticker (the white paper) so that the design attaches to the transfer foil (the transparent paper). You must then slowly and carefully remove the white paper completely from the wall. Here it is IMPORTANT that it is still the transfer foil (transparent paper) that lies down against the table and that it is the white paper you slowly pull off
  2. Now place your wall sticker on the transfer foil on the wall. Before, it is a good idea to have marked on the wall with a spirit level so that it sits straight.
    DRICKS! If your wall sticker is very large, it is an advantage that you are two about putting it up.
  3. You will now again need a scraper, ruler or Dankort to scrape over the transfer foil. Scrape really well all over the surface here. When you have finished scraping, you start with a small corner where you slowly pull a small piece at a time while constantly rubbing against the subject. This is to avoid air bubbles.
  4. Finally - slowly and carefully - peel off the entire transfer foil while making sure the subject is attached to the surface.